Wahl Magic Clipper Repair

I have a set of Wahl Magic Clippers, cordless, that have stopped working. initially I assumed there was a problem with the power cord because the power indicator light on the clippers would not light when the clippers were plugged in. I replaced the power cord, but that did not fix the clippers. The next most-likely failed part in the clippers is the circuit board, so I purchased a replacement board and installed it in the clippers. This fixed the problem, and this video will show how that can be done. The first circuit board I bought was purchased on Amazon for about $18. The listing said it was compatible with my exact model of clipper. But, when it arrived, it was not the same. So I had to go to https://www.goodmans.net/ to order the correct part. This cost $18.14 plus $6.50 for shipping. After tax, total cost was $26.14.

Here is the link to the exact part I purchased. https://www.goodmans.net/i/10023/wahl-90302-100-90302-101-clipper-charging-recepto.htm

I also purchased a soldering iron from Amazon. It cost $11.99 and worked as it should. This soldering iron has 5,329 reviews and is at 4.5 stars. Here is the link to that: https://www.amazon.com/dp/B0D4PPV8CR?ref=fed_asin_title&th=1

I purchased a charger from Amazon, that did not fix the problem, but does work. If you are looking for a new charger, you might want this one. Cost is $11.99.

https://www.amazon.com/dp/B07FKH11C9?ref=fed_asin_title

1. Remove outer cover.
2. Disconnect battery
3. Remove motor.
4. Unscrew wires from switch.
5. Remove wires from motor with soldering iron.
6. Solder wires from new circuit board onto motor.
7. Screw switch wires on to switch.
8. Ensure switch is in the off position, then reconnect battery.
9. Place power port into position and replace outer cover.
10. Test unit.